Many people are facing issues of rattling speakers, and they are looking for a solution to this problem. This blog post not only describes what a rattling speaker is and how it occurs, but also it provides us with some simple ways to fix this problem.
If you are having a rattling speaker, no worries. It is effortless to fix. Loose screws or loose wires usually cause the rattling speaker. So before you begin to disassemble your speaker, make sure all the cables are connected, and screws are tightened. Sometimes the speaker grille vibrates, and it can cause a rattling noise. In this case, you need to tighten the screws around the grille to stop the rattling.
Causes of Rattling Speaker
Rattling sounds in the speaker would usually be caused by one of the following reasons:
- Loose screws or bolts that hold the speaker in place.
- Loose wires that connect the speaker to the device.
- Loose-fitting speaker in the hole of the speaker hole.
- Loose-fitting hole of the speaker hole.
- Faulty speakers.
- Faulty electrical connections.
- Faulty audio jack.
If the above methods do not work, try blowing into or pressing the audio jack to see if the rattling stops. If that does not work, you can replace the audio jack and the speaker.
What is a rattling speaker?
A rattling speaker produces an audible rattle noise. It is due to a resonant vibration of the diaphragm of the speaker. Either low-frequency resonances typically cause rattling speakers at the speaker’s response range frequency or a much higher frequency caused by improper speaker placement.
How to fix a rattling speaker?
Speaker problems can be frustrating, especially when the problem is intermittent. Some rattling noises or distorted sounds may be caused by external interference, but these are usually easy to fix. Rule out external interference first by turning off nearby radios, televisions, cell phones or other devices.
You can repair it yourself or take it to a local shop for repair. If you fix it yourself, first remove the speaker grills. You may need to remove the screws that hold the grills and some plastic rivets. After removing the grills, take off the screws that hold the speaker in place. They may be on the bottom of the back of the speaker. After getting the screws loose, slowly pull the speaker out of the speaker enclosure.
How to prevent the speaker from rattling
The best way to prevent the speaker from rattling is to be aware of it—some situations where the speaker needs to be hung on the wall.
The speaker box is not entirely sealed, and the speaker can bounce.
But if the speaker is hung so that the speaker box is wholly filled, it will not happen.
Wall should be smooth and made of hard material to avoid the speaker from rattling. If the speaker is hung on the cart, rattling will not happen, but something will bounce. In this case, consider purchasing a cart with wheels.
The speaker must be installed correctly.
It is essential to check if it is in the centre of the room (ideally, you should install it in the centre) because it will cause a rattle if it is not.
Place the speaker against a wall will also have the same effect. Covering the back of the speaker with a big blanket or curtain will also help.
Conclusion:
We hope you enjoyed our blog about how to fix rattling speakers. A few different things can cause speaker rattling sounds. We recommend checking out our blog, which goes into detail about how to fix rattling speakers, including checking the screws or tightening the speaker, as well as possible speaker issues.
FAQs
Does a rattling speaker mean it’s blown?
The rattling sound you hear is not always a sign of a blown speaker. Several things can cause a rattling sound. If you notice a rattling sound with no music playing or a high-pitch squealing sound, this might be caused by a loose wire.
If the speaker is connected to the appropriate wires and the rattling persists, it is probably the speaker wire, not the speaker. It is especially true if the speaker is connected to a power cord. The rattling could be coming from the cord, not the speaker itself. It is more common with computer speakers.
Can you fix a vibrating speaker?
Yes, you can fix the vibrating speaker. The first thing you should do is check the screws, bolts and wire connectors for loss or rust. Check for water inside your speaker. If any water is found, try to dry the speaker immediately, at least 24 hours. It is better to use a hairdryer for its long nozzle.
After this, check for a low battery level in your phone. If it is found below, then recharge your phone. If there is a hardware problem, you have to bring your device to the service centre.
Can a blown speaker be repaired?
Sure they can, but you’d be better off buying a new one. The old-style speakers are repairable, but they’re getting more scarce and difficult to repair. So it’s better to buy a new one.